Call: 254-981-3316


In the past there were only three methods of dealing with the movement, cracking, and settling of concrete. The first, live with it. The second, permanently remove it. The third, totally replace it. Today there is a much better alternative, Raise It! Raising to repair concrete saves money and keeps concrete and steel out of our landfills.



Quick cure time – Polyurethane typically cures 15 minutes after injection allowing areas to be fully available in minutes not days.

Hydrophobic – Specially designed High Density Polyurethane can be used in underwater or wet applications.

Moisture barrier – Because of high density polyurethane characteristics, this foam-like material is resistant to water penetration.


Void Filling:

Concrete settling is not the only issue our foams can solve. Voids under slabs are often present in areas where wash out or excessive settling has occurred. This material will weigh on average 15-25 times less than a traditional mud jacking or cementitious grout mix, applying less stress on an already failed subgrade.

Joint/Slab Stabilization:

Slab stabilization is often required when slabs lack support, but may or may not be settled. Slabs can crack when loads exceeding its capacity are applied. Slab/joint stabilization applications require the voids to be filled to eliminate movement and offer support.

Call: (254) 981-3316


Facebook Message Sales: